Riding on hills/gradients
When climbing steep hills, the motorcycle may begin
to slow down and show lack of power. At this point
the rider should shift to a lower gear so that the engine
will again be operating in its normal power range. Shift
gears rapidly to prevent the motorcycle from losing
momentum.
When riding down a hill, the engine may be used as
brake by shifting to a lower gear.
STOPPING AND PARKING
1. Close the throttle completely and apply both the
brakes simultaneously.
2. Down shift the gears with clutch lever pressed /
disengaged as the road speed decreases. Bring
the engine to neutral position just before the
vehicle stops.
3. Turn the ignition ‘OFF’.
4. Park the vehicle on a firm, flat surface.
5. Lock the steering.
Reduce speed to a safe limit before turning/cornering.
Do not apply brake while turning/cornering. Do not
disengage clutch before braking.
Since the engine and exhaust system becomes very
hot, make sure to park the vehicle in a place where
pedestrians or children are not likely to touch the hot
surface. Do not park near dry grass or any other
flammable resources which might catch fire.
To avoid deterioration of paint gloss due to ultra violet
rays and heat of sunlight, always park your motorcycle
in a covered parking.
Warning
Warning
RIDING YOUR TVS APACHE RTR 200 Fi4V
59
To Next Page
Loading...
Need help?
General
