Failure to switch the turn signal lamp 'ON' or 'OFF' at
the right time may lead to an accident.
Use appropriate head lamp beam 'high / low' as per
the traffic and road conditions for your safety and to
avoid inconvenience to other riders.
It is strongly recommended to ride the vehicle in 'low'
beam during day.
18
Warning
Warning
Clutch lever can be set to your convenience. Refer
page no. 56
Pass by system will not work if the head lamp is
glowing in 'High' beam.
Only the engine is started the head lamp high beam
glows, provided if the beam control switch is in high
beam.
11
Note
Note
Note
6. Head lamp high / low beam switch
The head lamp low beam glows automatically. Only
the head lamp beam (high/low) can be controlled with
the beam control switch.
Press the top end of switch for 'High' beam ' ' and
bottom end for 'Low' beam ' '.
Low beam of the vehicle is turned on with Ignition key
ON and high beam is activated once the engine is
started and switch is in High beam position.
4. Adjustable clutch lever
Press the lever towards grip to disengage the drive. It
is used to disengage the clutch while shifting the
gears.
5. Pass-by switch
Press the switch to flash the head lamp. It is used to
give signal to the vehicles coming from the opposite
direction while overtaking other vehicles during day.
The head lamp glows automatically once the engine is
started. If the head lamp is glowing in 'Low' beam, on
pressing the switch, the head lamp 'High' beam also
glows along with the 'Low' beam.
If the head lamp is already glowing in 'High' beam, the
pass-by system will not work.
KNOW YOUR TVS APACHE RTR 200 Fi4V
To Next Page
Loading...
Need help?
General
