Don't's
● Do not use non-standard tyres.
● Do not pump the brakes. Apply the brakes
continuously.
● Do not ignore any warning lamp on speedometer.
● Do not adjust the wheel speed sensor air gap your self.
● Do not run the engine and ride or rotate the rear wheel
alone in gear with vehicle on centre stand, for drive
chain lubrication, during water wash etc.,
● Do not attempt to correct the toner ring teeth by
bending manually or by using any other method.
DO’S AND DON’T’S
Do’s
● Check the ABS warning lamp for any warning
before driving the vehicle.
● Apply both front and rear brake for better
performance.
● Apply continuous brake in ABS mode for better
performance. Do not pump.
● Perform the periodic maintenance as per the
schedule.
● ABS should be serviced only at TVS Motor
Company Distributor, Dealers and Authorised
Service centers.
● Carefully remove the wheel during puncture / tyre
replacement to prevent toner ring damage / bend.
● Keep the wheel in such a way that the toner ring
is facing upwards.
● Always use recommended brake fluid. Use fresh,
clean brake fluid.
● Use only the recommended make, type and size of
tyre (ABS tuned with tyre specified by the TVS
Motor Company).
05
ABS only helps in improving the vehicle control. It is
always good to remember not to exceed the physical
limits of the vehicle stability. It is rider's responsibility to
ride at a suitable speed, while taking care of conditions
and road surface. ABS will not compensate for errors in
the judgement or improper brake use in the various
situation. ABS never eliminates the danger of falling while
turning.
Hard braking during sharp cornering on slippery surface
may lead to vehicle instability. Under such circumstances
gradual braking is recommended.
Warning
ANTI-LOCK BRAKING SYSTEM
To Next Page
Loading...
Need help?
General
