Tyre tread condition
Operating the vehicle with excessively worn tyres will
decrease riding stability and can lead to loss of control.
It is recommended to replace the tyre when the tyre
wears off to the tyre wear indicator level (indicated by
TWI on the tyre).
Tyre rotation direction
While reassembling the tyre, after removing from
wheel rim, ensure that the arrow mark (A) provided on
the tyre, faces the direction of wheel rotation.
Tyre puncture
TVS Apache RTR 200 Fi 4V is fitted with a tubeless
tyre on both front and rear wheel. lncase of any
puncture / tyre damage it is advised to visit nearest
tyre manufacturer Dealer or the tyre repair shops who
know the repairing methods of tubeless tyre. It is not
necessary to remove the tyre from wheel rim always
to attend the puncture. Even though, if there is a need
of tyre removal, it is strongly recommended to use a
tyre removal / fitment machine.
MAINTENANCE
* The pneumatic tyres fitted in this vehicle meet
the requirements specified by BIS and comply
with the requirements under the Central Motor
Vehicles Rules (CMVR), 1989.
Caution
Side walls of the tubeless tyres which are in contact
with the wheel rim are only seals the air inside the
wheel assembly. Hence, care should be taken not to
damage the side walls of the tyres during removal /
reassembly.
Wheel balancing to be done every 1 year or every
12000 km. In addition, after every tyre puncture
repair or tyre replacement, wheel balancing to be
done.
79
To Next Page
Loading...
Need help?
General
