Press the 'Info switch' again to stop the current lap
timer and to start a new lap. Existing lap timings will
be displayed as shown below and continue to get
updated whenever a new lap is started and stopped.
Long press the 'Info switch' for few seconds (more
than 1 second and less than 3 seconds) to stop the lap
timer count.
To start a lap timer again, after stopping it by pressing
the 'Info switch', the lap timer need to be reset as
explained page No. 34. You can record any number of
laps but last three lap's details only will be displayed in
the cluster.
12d. Notification area
A general purpose notification area where, ride mode
information, error information, service due,
connectivity information, warnings are displayed. In
this area if the mobile device is not connected, Avg.
speed is displayed. If bluetooth device is connected
same Avg. speed can be accessed using "SET"button
on speedometer.
12e. High speed indicator
High speed indicator records the maximum speed
(top speed) achieved by the rider so far either in km/h
or mph as per preferred setting. You can reset and
record the new speed if required. Refer page No. 34
for resetting the high speed data. On entering th high
speed mode previously achieved high speed data will
be displayed in the instrument cluster as shown.
Lap timer works only when the lap timer mode is
active. Once the lap timer is stopped by pressing the
'Info switch', the timer cannot be started again until
the timer is reset. Only last three lap's timing will be
displayed in the cluster on entering the lap timer
mode.
Note
26
KNOW YOUR TVS APACHE RTR 200 Fi4V
To Next Page
Loading...
Need help?
General
