This ABS warning lamp goes 'OFF' once the bike
reaches 10 km/h speed and above incase of dual
channel vehicles or 7 km/h speed and above incase of
single channel vehicles and blinks whenever the bike
speed is less than 6 km/h speed (only in single
channel vehicles) indicating that the ABS is working
fine.
If the warning lamp glows continuously even after
the bike crossing the specified speed limits, then the
ABS has an error and your bike should be taken to any
of our nearest TVS Motor Company Distributor,
Dealers and Authorised Service Centers.
When you brake, bear in mind that ABS control cannot
always be relied on to prevent the rear wheel from lifting
clear of ground.
ABS warning lamp
The TVS Apache RTR 200 Fi 4V does an automatic self
check every time when the ignition switch is turned 'ON'.
The ABS warning lamp provided at the speedometer
console blinks and informs you that the ABS is under
check.
04
The ABS can apply and release the pressure in the
brake circuit much faster than that rider can do with
brake lever / pedal to avoid wheel locking. So there is
no need to pump the brake, it requires only
continuous application.
Incase of single channel ABS system, only the
front brake of your motorcycle is fitted with ABS
system and not the rear brake. Applying rear
brake alone can cause wheel skidding just like
normal braking system incase of single channel
ABS system. Always apply both front and rear
brake for better performance.
Warning
ANTI-LOCK BRAKING SYSTEM
To Next Page
Loading...
Need help?
General
