Tyco AutoPulse Z-10 User Manual

4-3
Complete the following steps to enable the panel for text-based programming.
Step 1. Connect Serial Cable. Connect a Part No. 431206 serial cable between the PC and
the AutoPulse Z-10 service port, as follows:
a. Locate the PC within 6 feet of the AutoPulse Z-10 FACP and connect a Part No. 431206
serial cable to a free serial port (typically COM1) on the PC.
b. Connect the other end of the cable to the service port on the AutoPulse Z-10 FACP. The
Service port, labeled P2, is located on the top left of the AutoPulse Z-10 motherboard.
Make sure the stripe on the cable is positioned at the bottom, as shown in the following
figure.
Figure 4-1. Connecting Cable to Service Port
Continued on next page
Overview, Continued
Text-Based
Programming
Part No.
431206
Serial
Cable

Tyco AutoPulse Z-10 Specifications

General

Brand	Tyco
Model	AutoPulse Z-10
Category	Control Panel
Language	English