1-3
The AutoPulse Z-10 ships from the factory with 13 applications installed in memory.
Programming the panel involves selecting an application to use, as well as an option, such as NAC
operation, manual and automatic delays, and/or other site-specific functions.
The panels with software version 1, 2, or 3 have 9 applications. The panels with version 4.01 or
higher have the 13 applications noted above. Table 1-1 lists the original 9 applications, along with
the aux and expansion relay operation for those applications if the “original” relay operation is
selected. The table also describes the operation of the Notification Appliance Circuits (NACs) and
Releasing Appliance Circuits (RACs), along with the functions of the four Initiating Device
Circuits (IDCs) and two Special Purpose Monitor (SPM) circuits. Refer to Chapter 4 of this
manual for detailed programming instructions.
Table 1-2 lists all 13 applications with the aux and expanded relay operation if the enhanced relay
operation is selected. The table also describes the operation of the NACs and RACs along with the
functions of the four Initiating Device Circuits (IDCs) and two Special Purpose Monitor (SPM)
circuits. Refer to Chapter 4 of this manual for detailed programming instructions.
Note: Applications 10-13 use only the relay operation shown in Table 1-2.
Continued on next page
Supported Applications
Pre-Programmed
Applications
To Next Page
Loading...
Need help?
General
