F3200 Operator's Manual Document No: LT0119
Network Systems
Page 11-30 29 July 2002 Issue 2.04
Three numeric values for SID.Responder.Point should then be entered, followed by
either the:
OR
Isolate/De-Isolate
The name and number of the selected point will be shown and options of:
1: Isolate 2: De-isolate.
Press numeric key 1 or 2 and the display will show “Sending Command” and after a brief
period, “Command Accepted” or an error message.
Reset
The name and number of the selected point will be shown and options of:
1: Point 2: History 3: Tracking
Press numeric key 1, 2 or 3 and the display will show “Sending Command” and after a
brief period, “Command Accepted” or an error message.
To Next Page
Loading...
