EasyManuals Logo

UFactory xArm 5 User Manual

UFactory xArm 5
182 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #62 background imageLoading...
Page #62 background image
62
1.2.3 Connect to the Robotic Arm
There are the following two ways to communicate with the robotic arm.
1. If you access xArm Studio software, you can communicate with the robotic arm
through the following steps:
(1) Download xArm Studio
xArm Studio download address:
https://store-ufactory-cc.myshopify.com/pages/download-xarm
(2) Install xArm Studio software
(3) Open the xArm Studio software, and enter the IP address of the control box in the
search box (the default IP address of the device has been marked on the side of the
control box)
2. If you use a browser to access xArm Studio, you can communicate with the robot
through the following steps:
(1) Open the browser
(2) Enter in the search bar: the IP address of the control box: 18333
For example, if the IP address of the control box is 192.168.1.135,
enter 192.168.1.135:18333 in the search bar to access xArm Studio.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the UFactory xArm 5 and is the answer not in the manual?

UFactory xArm 5 Specifications

General IconGeneral
BrandUFactory
ModelxArm 5
CategoryRobotics
LanguageEnglish

Related product manuals