What to do if UniPOS Control Panel has low backup batteries?
If your UniPOS Control Panel indicates low backup batteries, especially after a mains power interruption, you should either restore the mains power supply or replace the backup batteries.
What to do if UniPOS IFS7002 shows a communication error or fault in a device?
If your UniPOS Control Panel displays a communication error with a device or indicates a fault in the device, you should repair or replace the device. If replacing, run a clean initialization of the control panel.
Why is the isolator of addressable device activated on my UniPOS IFS7002?
If the isolator of an addressable device is activated on your UniPOS Control Panel, it indicates a fault, such as a short circuit in the loop. You need to eliminate this fault.
What to do if UniPOS Control Panel indicates a removed device?
If your UniPOS Control Panel reports a removed device, you should install the device to resolve the issue.
How to clean a contaminated sensor in UniPOS IFS7002?
If your UniPOS Control Panel indicates a contaminated sensor (specifically in detectors with an optical-smoke part), remove the detector, clean the optical part, and then reinstall it.
What to do if UniPOS Control Panel shows fault condition uninitialized loop?
If your UniPOS Control Panel displays a fault condition indicating an uninitialized loop, you should: 1. Eliminate the fault (open loop). 2. Restore the loop to comply with the configuration saved in the control panel and start initialization. 3. Start a clean initialization of the control panel.
What to do if UniPOS Fire Alarms have low backup batteries?
If your UniPOS Fire Alarms have low backup batteries because of an interrupted mains power supply, you should restore the mains power supply or replace the backup batteries.
What to do if UniPOS Fire Alarms activated isolator of addressable device?
If the isolator of an addressable device in your UniPOS Fire Alarms is activated, the solution is to eliminate the fault, which is likely a short circuit in the loop.
How to fix uninitialized loop fault in UniPOS Fire Alarms?
If your UniPOS Fire Alarms display a fault condition due to an uninitialized loop, you should: 1. Eliminate the fault (open loop). 2. Restore the loop so it complies with the configuration saved in the control panel and start initialization of the control panel. 3. Start a clean initialization of the control panel.
How to clean contaminated sensor in UniPOS Fire Alarms?
If your UniPOS Fire Alarms are showing a fault due to a contaminated sensor (only in detectors with optical-smoke part), remove the detector, clean the optical part, and then place it back.
Outlines the process for device addressing and initialization procedures.
Details the various modes and sequences of operation for the panel.
Explains what happens when a fire condition is detected in a zone.
Details visual and audible indications during fire condition.
Explains keypad operations and controls during a fire condition.
Explains the causes and nature of fault conditions in the system.
Details visual and audible indications for various fault conditions.
Explains keypad operations and controls during a fault condition.
General| Monitored inputs | 8 |
|---|---|
| Battery voltage | 24V DC |
| Display | LCD |
| Touch Screen | No |
| Processor | ARM Cortex-M3 |
| Operating Temperature | -10°C to +55°C |
| Operating System | Proprietary |
| Memory | 512KB Flash |
| Communication Interfaces | RS485, Ethernet, USB |
To Next Page
