UniPOS IFS7002 User Manual

UniPOS IFS7002 two signal loops
Instruction Manual Page 40
Revision 11/01.17 Of 145
The screen Panel Outputs
provides information for outputs
responding to the relevant phase of
Fire condition in the zone:
The screen List of addressable
outputs displays information for
addressable outputs associated to
the zone. If no such outputs are
available, a screen displaying the
message No addressable outputs
activated upon Fire condition Phase
X appears. (X stands for the phase
number – 1 or 2). The only option
then is to exit the screen. If
addressable outputs associated to
the zone are available, their list is
visualized. Loop number, device
address in the loop and the number
of the output in the device, if more
than one is displayed for each
device. The list is visualized in
pages, each page containing a
maximum of 10 devices.
The buttons and on the right panel section appear where more than one page is available
and allow the user to switch between next and previous page.
Mode:DAY LOC АctInp 0000 11:29:21 Sat 13 Mar 2010
FIRE CONTROL PANEL IFS7002
UniPOS
Parameters: Zone 1 Fire Phase 1 Outputs
Panel Outputs
Monitored Output 1 No
Monitored Output 2 No
Relay Output Yes
Mode:DAY LOC АctInp 0000 12:23:45 Sat 13 Mar 2010
FIRE CONTROL PANEL IFS7002
UniPOS
Parameters: Zone 1 Fire Phase 2 Outputs
List of addressable Outputs Total: 10
Loop1 Addr7.2 Loop1 Аddr8
Loop1 Аddr7.3 Loop2 Аddr9
Loop1 Аddr7.4 Loop2 Аddr10.1
Loop1 Аddr7.5 Looр2 Аddr11.1
Loop1 Аddr7.6 Loop2 Аddr12

UniPOS IFS7002 Specifications

General

Brand	UniPOS
Model	IFS7002
Category	Control Panel
Language	English