UniPOS IFS7002 two signal loops
Instruction Manual Page 75
Revision 11/01.17 Of 145
5.2. Where no uninitialized
devices are detected
appears the following
screen:
The function is waiting for
new device to be installed
in the loop or to press
button to exit the
function.
5.3. In case two or more
uninitialized devices are
detected in either of the
loop lines, i.e. more than
one branch exists at one
point and devices without
addressing are detected in
more than two branches
(in the loop and in more
than one branch) the
following screen appears:
In such case the number
of uninitialized devices
shall be reduced until the
above set requirements
are met.
5.4. Where the provisions in sections 5.1, 5.2 and 5.3, are not met, a command for illumination
of devices LEDs is sent to the uninitialized (or to one of the uninitialized) device. Depending
on the result of the communication one of the following screens appears:
Mode: DAY LOC 15:56:42 Tue 22 Mar 2010
Mode: DAY LOC 15:56:42 Tue 22 Mar 2010
To Next Page
Loading...
Need help?
General
