M
ACHINE
P
REPARATION
& O
PERATION
Section
2.7
2-12 SB80 Work Platform - European
Lubrication
Refer to Section 3 for lubrication chart and guide-
lines.
Battery Maintenance
Check battery fluid level daily, especially if work plat-
form is being used in a warm, dry climate.
If electrolyte level is lower than 10 mm (3/8 in.) above
plates add distilled water only. DO NOT use tap water
it will shorten battery life.
Keep terminals and top of battery clean.
Tires
Tire selection can affect the stability of the machine.
Use only tires supplied by UpRight (15-22.5 NHS
Tubeless 16 Ply Rating) unless approved by the man-
ufacturer in writing. Check tire air pressure daily. (7
bar) (100 psi) (Not required for foam-filled tires).
WARNING
!
!
Hazard of explosive gas mixture. Keep sparks,
flame and smoking materials away from batter-
ies. Always wear safety glasses when working
with batteries. Battery fluid is highly corrosive.
Rinse away any spilled fluid thoroughly with
clean water.
WARNING
!
!
Do not operate machines with Plus3 option
unless machine is equipped with foam filled
tires. Remove machine from service and install
proper tire/wheel combination before operating
machine.
To Next Page
Loading...