5-42
Operation on the Machine > Sending
3
Press [WSD Scan/DSM Scan].
If WSD Scan on page 8-45 is set to [Off] in the network settings, press [DSM Scan] and go to
step 5.
4
Select [DSM Scan] and press [Next].
5
Select the scan process to be used and press [OK].
Press [Reload] to reload the computer list.
To check the settings, press [Detail].
6
Change the settings and add destinations as needed.
Only E-mail addresses can be added as destinations.
In the send base screen, press [Detail/Edit], [Destination], and then [Address Book] or [E-mail
Addr Entry], and add a destination.
In some scan processes, it may not be possible to change settings or add destinations.
7
Press the [Start] key.
Sending starts.
To Next Page
Loading...
