6.5 Installation of a battery for the Real Time Clock (RTC) 105
6.6 Galvanic isolation barriers 105
7 Commissioning and additional instructions 107
7.1 Commissioning safety 107
7.2 Commissioning of the drive 107
7.3 Operation of the motor 108
7.3.1 Checks before starting the motor 108
7.4 Measuring the cable and motor insulation 108
7.5 Installation in a marine environment 109
7.6 Installation in an IT system 109
7.6.1 The EMC jumper in MR4, MR5 and MR6 109
7.6.2 The EMC jumper in MR7 112
7.6.3 The EMC jumper in MR8 114
7.6.4 The EMC jumper in MR9 115
7.7 Maintenance 116
8 Technical data, Vacon
®
100 118
8.1 AC drive power ratings 118
8.1.1 Mains voltage 208-240 V 118
8.1.2 Mains voltage 380-500 V 120
8.1.3 Mains voltage 525-600 V 121
8.1.4 Mains voltage 525-690 V 122
8.1.5 Overload capability 122
8.1.6 Brake resistor ratings 123
8.2 Vacon
®
100 - technical data 128
9 Technical data, Vacon
®
100 FLOW 133
9.1 AC drive power ratings 133
9.1.1 Mains voltage 208-240 V 133
9.1.2 Mains voltage 380-500 V 135
9.1.3 Mains voltage 525-600 V 136
9.1.4 Mains voltage 525-690 V 137
9.1.5 Overload capability 137
9.2 Vacon
®
100 FLOW - technical data 139
10 Technical data, Vacon® 100 HVAC 144
10.1 AC drive power ratings 144
10.1.1 Mains voltage 208-240 V 144
10.1.2 Mains voltage 380-500 V 145
10.1.3 Overload capability 146
10.2 Vacon
®
100 HVAC - technical data 147
11 Technical data on control connections 152
11.1 Technical data on control connections 152
TABLE OF CONTENTS VACON · 7
24-HOUR SUPPORT +358 (0)201 212 575 · EMAIL: VACON@VACON.COM
To Next Page
Loading...
Need help?
General
