Camera Configuration
Set HDMI resolution and IR forwarding using the switches on the back of the camera:
n Set HDMI output resolution using the rotary switch.
n Set DIP switch 3 DOWN to enable IR forwarding.
Codec Control Mode and other configuration settings are available from the camera's web interface. Point
the remote at the camera and press the Data Screen button to see the camera's IP address on the
connected HDMIdisplay.
Enable Codec Control Mode on the DIP Switches tab of the System page.
Keep in mind that the OneLINK HDMI receiver displays its own IP address, not the camera's IP address.
Note
Codec Control Mode was added to Vaddio cameras in early 2018. Your camera may require a firmware
update to add this capability.
40
Integrator's Complete Guide to the OneLINK HDMI Camera Extension
To Next Page
Loading...
