system factory-reset
Gets or sets the factory reset status. When the factory reset status is on, the OneLINK device resets to
factory defaults on reboot.
Note
This does not reset the camera.
Synopsis system factory-reset {get | on | off}
Options
get
Returns the camera's current factory reset
status.
on
Enables factory reset on reboot.
off
Disables factory reset on reboot.
Examples
>system factory-reset get
factory-reset (software): off
factory-reset (hardware): off
OK
>
Returns the factory reset status.
This evaluates the most recent system factory-reset on or off command, if
one has been received, then reads the rear panel DIP switches and returns the
status on if they are all in the down position.
>system factory-reset on
factory-reset (software): on
factory-reset (hardware): off
OK
>
Enables factory reset upon reboot.
Note
This command does not initiate a factory reset. The factory reset takes place on the
next reboot.
sleep
Pauses for the specified number of milliseconds before evaluating and executing the next command.
Synopsis sleep <milliseconds>
Options <milliseconds> The number of milliseconds (1 to 10000)to
pause.
Example
>sleep 7000
OK
>
Pause for 7 seconds (7000 milliseconds) before returning.
61
Integrator's Complete Guide to the OneLINK HDMI Camera Extension
To Next Page
Loading...
