VADDIO OneLINK HDMI - Onelink HDMI for HDMI Cameras

OneLINK HDMI for Vaddio HDBaseT Cameras with Cisco Codecs, 999-9575-000/001/009
Camera and codec not included.
Note
If connecting to a Cisco SX20 codec, you will need to provide
a Cisco split cable, Cisco part number CAB-PHD4XS2-
SPLIT.
n OneLINK HDMI Receiver
n Power supply, 48 VDC/1.36 A, with AC cord set(s)
n HDMI cable, 3 ft. (0.9 m)
n Custom-pinout Cat-5e cable for Cisco, 3 ft. (0.9 m)
n EZCamera RS-232 control adapter 998-1002-232
n Cat-5e patch cable, 3 ft. (0.9 m)
n Quick-Start Guide 411-0019-01
OneLINK HDMI for HDMI Cameras
OneLINK HDMI for RoboSHOT HDMI Cameras, 999-9590-000/001/009
Camera not included.
n OneLINK HDMI Receiver
n OneLINK EZCamera Interface Module (EZIM) with
mounting screws
n Power supply, 48 VDC/1.36 A, with AC cord set(s)
n Power cable EIAJ-04 to EIAJ-04, 1 ft. (0.3 m)
n Cat-5e patch cable, 1 ft. (0.3 m), qty. 2
n HDMI cable, 1 ft. (0.3 m)
n EZCamera RS-232 control adapter
n Quick-Start Guide 411-0019-02
OneLINK HDMI for Sony and Panasonic Cameras, 999-9530-000/001/009
Camera not included.
n OneLINK HDMI Receiver
n OneLINK EZCamera Interface Module (EZIM)
n Power supply, 48 VDC/1.36 A, with AC cord set(s)
n Power cable EIAJ-04 to EIAJ-04, 1 ft. (0.3 m)
n Power cable EIAJ-04 to 3x6.3mm, 1 ft (0.3 m)
n Wall mount with mounting hardware for Sony and
Panasonic cameras
n HDMI cable, 1 ft. (0.3 m)
n RJ-45 to 8-pin mini-DIN cable, 1 ft. (0.3 m)
n Cat-5e patch cable, 1 ft. (0.3 m)
n Quick-Start Guide 411-0019-02
4
Integrator's Complete Guide to the OneLINK HDMI Camera Extension