Ceilometer CT25K
CT25K-U059en-2.1 User’s Guide
29
1st (TOP)
LEVEL
2nd LEVEL 3rd LEVEL 4th LEVEL 5th LEVEL DESCRIPTION
SET MESSAGE ANGLE_COR OFF Angle correction: Cloud and vertical visibility heights (distances) in
messages are NOT corrected for the tilt angle
ON Angle correction: Cloud and vertical visibility heights (distances) in
messages ARE corrected for the tilt angle
ANGLE_MEAS AUTO Automatic angle measurement for angle correction
MANUAL 0..89 Manual angle value (degrees) for angle correction
HGTH_OFFSET -1000... 1000 (ft)
or -304... 304 (m)
Height Offset: Cloud and vertical visibility values are corrected by
this offset value. Positive values add to, negative values subtract from
measured height. Unit is m or ft. as set by UNITS command.
MANUAL_MSG "30 01000 02000
03000 12345678"
Sets test message (example)
"" Cancels manual message
MODE AUTOSEND Measurement messages are transmitted automatically as set by
command INTERVAL
POLLING Measurement messages are transmitted according given polling string
PORT DATA Message is directed to the Data port (default), non-volatile
MAINTENANCE Message is directed to the Maintenance port, non-volatile
PROFILE SCALE 0...999 Factor for scaling the range gate data items of Message No. 2.
Normal value: 100 (%)
NOISE_H2 OFF Range gates data is range normalized only if backscatter is contained
ON Range gates data is always range normalized , even noise
TYPE MSG1 Message No. 1 is transmitted
MSG2 Message No. 2 is transmitted
MSG3 Message No. 3 is transmitted
MSG6 Message No. 6 is transmitted
MSG7 Message No. 7 is transmitted
STATUS Status message is transmitted
UNITS FEET Reported heights unit is feet
METERS Reported heights unit is meters
WARN_DELAY OFF Warning character W is set in message immediately
ON Warning character W is set in message after 5 minutes delay
VLIM 1...100 Set vertical visibility reporting limit (%) for sky condition
To Next Page
Loading...
