Vaisala FS11 - Page 9

_________________________________________________________________________________
VAISALA _________________________________________________________________________ 7
Figure 41 Assembling and Attaching Calibrator ......................... 129
Figure 42 Installing Mask Plates onto Opaque Glass Plates .. 131
Figure 43 Visibility Sensor Controller FSC102 ............................ 140
Figure 44 VS Bottom View, Central Compartment Cover
Screws ................................................................................. 141
Figure 45 FSI102 Interface Unit....................................................... 142
Figure 46 Power and Battery Switch Locations .......................... 143
Figure 47 FSC202 Connectors and Cover Plate Screws ........ 144
Figure 48 FSC202 Screws and Connectors ................................ 145
Figure 49 FSP103 Parts..................................................................... 147
Figure 50 Visibility Sensor Transmitter and Receiver
Control Cables ................................................................... 149
Figure 51 End Plug Removal (Shown for Transmitter) ............. 150
Figure 52 Module Retainer Removal (Shown for
Transmitter) ........................................................................ 150
Figure 53 Pushing Control Cable into Optics Head ................... 151
Figure 54 Transmitter Resp. Receiver Module, Control
Cable Disconnected ......................................................... 151
Figure 55 Pulling Control Cable out of Housing Tube .............. 152
Figure 56 Transmitter/Receiver Module O-Ring ......................... 152
Figure 57 End Plug with O-Ring ...................................................... 153
Figure 58 FSP103 and FSC202 Sensor Cable
Connections ....................................................................... 155
Figure 59 Location of Fuses on FSP103 Board.......................... 157