1021
Model Code Page
67. Powered front axle Carraro
1. 10. 1999
8450--8950 672 3
8. Remove the wheel bearing outer races in the hub flange
and fit new ones. Removing can be done e.g. with a drift
and a hammer. When fitting new races, they can be co oled.
9. Fit a new cassette seal with plate ETV 894 460.Grease
the seal lips.
10. Fit a new inner tapered roller bearing on the knuckle
housing. The bearing can be warmed up to +80˚ C.
11. Det ach, when necessary, the ring gear by releasing
circlip (H) with a suitable pliers. Remove, when necessary,
steel sleeves (I) and fit new ones.
12. If you change the steel sleeves, prefit the sleeves into
ring gear support so that two sleeves protrude some milli-
metres to guide the ring gear support when fitting it.
13. Fasten the ring gear onto support and secure it with the
snap ring.
14. Press the hub flange into place so that t he inner bearing
outer race fits onto the roller bearing on the knuckle hous-
ing.
15. Push the outer wheel bearing against its outer race in
theflange.Thebearingcanbewarmedupto +80˚ C.
16. Place the ri ng gear onto the hub. Tap in all steel sleeves
to their boring. Fit and tighten the ring gear support bolts to
230 Nm.
17. Refit the washers in a correct order and secure them
with the circlip.
To Next Page
Loading...
