or COM2
or COM2
33700600, L=1,5 m
or 33700610, L=8,0 m
9
10
A1A6
A1A5
T ransmission Control
U n i t A C --- 5 . 2
Part. no................
Software Version........
ParameterVersion ...
Tractor mode..........
Date/Name............
diskettes part. no. page 370/24G
diskettes part. no. page 370/24G
long dis-
tance.
Par t. no.=.....
Software Version=.....
Par a meter Version=.....
Tractor model=.....
Date/Name=.....
147
1. 9. 2002
370 24E
6250--8950
37. Autocontrol 5/5.2
Modell Code Page
C.4 Loading the parameter file (Do this al-
ways after loading a program file ! )
7. Click the button PARAMETERS > click the button
”Browse” > choose directory ” Parameters ”(clickthe
yellow button where there is an arrow up and choose direc-
tory P arameters by double ---clicking) > choose a para-
meterfile(double---click)>thechosenfileappearsinthe
window ” File ” > click the button ” Begin download ”>a
loading process begins and a blue bar at the lower part of
the window begins to grow > when the loading process is
successful the text ” Parameter download successful! ”
appears in the white window.
NOTE! On page 370/24F there are tips for error situations,
if the parameter file loading has not succeeded.
C.5 Checking and markings
8. Click the button ” Version ”>afterafewsecondsthe
program identification number e.g. 86 17 can be seen in
the white window (check code 1) > confirm that the check
code corresponds to the tractor model (see page
370/24G).
9. Turn the power off (switch off program unit or ignition
switch) > if the more control units are not going to be pro-
grammed, exit from the Loader program by clicking X button
(at the upper right corner of the window). Disconnect the pro-
gramming cable from the connector X43.
If an unfixed control unit is being programmed, let the
connec-
tors of the programming unit be connect ed in the control unit
(fastening of the label in right position is easier) .
10. New control unit: Fill out an adhesive label (part no and
file names and tractor model) > fasten it on the control unit in
right position (see picture 1) > disconnect the cables from the
control unit.
C.6 Settings after prog ramming (after fixing the
control unit in the tractor)
11. Carry out settings and test ---drive according to the instruc-
tions at page 370/24A.
To Next Page
Loading...
