24. Lightly lubricate two new o-rings (A, Figure 152) with
clean engine oil and insertinto crankcase flange.Be sure
that old o-rings are not installed, as stacking old and new
o-rings will cause oil leaks.
152
25. Lubricate the camshaft PTO bearing journal, and
camshaft bearing bore in crankcase cover with clean
engine oil.
26. Apply a thin film of clean engine oil to PTO bearing oil
seal lip.
27. See Figure 153. Verify that governor cup is installed on
governor gear shaft.
153
28. Verify two locating pins are present on crankcase flange.
Install new locating pins if damaged or missing.
122 vanguardpower.com
To Next Page
Loading...
Need help?
General
