Varec 2920 - Page 79

5 Display and Configuration Interface
Varec, Inc. 69
Pnt Checksum CRC-16 Checksum of point's static configuration
parameters.
Config Params
LevelRef ENC Level
RTD Temp
AI Value
NMT53 Avg Temp
NMT53 Vap Temp
NMT elem. #00 through #17
HART1 PV Value
HART1 SV Value
HART2 PV Value
HART2 SV Value
HART3PV Value
HART3 SV Value
FMR Level
FMR Measured Dist.
FMR Meas. Level
Undefined
TempRef ENC Level
RTD Temp
AI Value
NMT53 Avg Temp
NMT53 Vap Temp
NMT elem. #00 through #17
HART1 PV Value
HART1 SV Value
HART2 PV Value
HART2 SV Value
HART3PV Value
HART3 SV Value
FMR Level
FMR Measured Dist.
FMR Meas. Level
Undefined
CritLowLevel This value indicates the point at which the Critical Low
Level alarm should be activated. When the incomming
value falls below this point the alarm is activated and
de-activated when the value is above this point.
AdvLowLevel This value indicates the point at which the Low Alarm
Level should be activated. When the incoming value falls
below this point the alarm is activated and de-activated
when the value is above this point.