CTC II • Edition 01/2009
A2C59512809 © Continental Trading GmbH 11
For your safety
Important notes on rolling road test stands
1.5.2 Notes on rolling road test stand operation
• The rolling road test stand must be used in accordance
with the instructions of the test stand's manufacturer and
the relevant Operating Instructions must also be
adhered to.
• The test stand type was set up by a VDO service partner
during installation. No modifications may be made!
• While working at the test stand, adhere to the relevant
trade association's safety and accident prevention
regulations.
• The rolling road test stand must be checked for wear
and tear of the roller sets before testing takes place
(measure the measuring roller if necessary).
Only a VDO service partner may adjust the rollers.
• During testing and measurement,
– the speed must always be kept regular.
– the prescribed tyre pressure must be adhered to.
– the roller's load limit may not be exceeded.◄
Important
To Next Page
Loading...
