CTC II Tachograph programming
Operating Instructions Date and Time
66 © Continental Trading GmbH A2C59512809
10.4.2 Start and end of daylight saving
At the factory, the current change-over times (start/ end of
daylight saving) and offsets for the EU member states are
stored in the test device for the next ten years.
The CTC II is used to program change-over times into the
MTCO 1324 for the next five year.
Northern and
southern
hemispheres
When programming change-over times you must make a
note of countries on the northern and southern hemisphere as
the the start and end of daylight saving time will differ.
Daylight saving time changes (start and end of daylight
saving) can only be set for the MTCO 1324.◄
Important
Year Start of daylight
saving time
Offset End of daylight
saving time
Offset
2009 29th March, 2:00 + 1 h 25th October, 3:00 0 h
2010 28thMarch, 2:00 + 1 h 31st October, 3:00 0 h
2011 27thMarch, 2:00 + 1 h 30th October, 3:00 0 h
2012 25thMarch, 2:00 + 1 h 28th October, 3:00 0 h
2013 31stMarch, 2:00 + 1 h 27th October, 3:00 0 h
2014 30thMarch, 2:00 + 1 h 26th October, 3:00 0 h
Fig. 7: Daylight saving time - Northern and southern hemispheres
To Next Page
Loading...
