CTC II Entering a PIN for the workshop card
Operating Instructions PIN via PIN DIRECT
32 © Continental Trading GmbH A2C59512809
4 Entering a PIN for the workshop card
Thanks to the CTC II, the workshop card PIN does not have
to be entered into a tachograph. However, PIN entry is only
possible if this function has been activated by your VDO
service partner.
Here the method of entry for the workshop card PIN (PIN
direct or User selection) is specified. This is dependent on the
legitimacy of the action in your specific country.
4.1 PIN via PIN direct
The workshop card PIN is not saved in the CTC II - entering
it by keyboard merely simplifies the procedure. The value
entered is sent directly to the digital tachograph.
If you select the key, you can choose between upper case,
lower case and special characters. Observe the display here
([ABC], [abc], [123], special characters).
Press and to select special characters. ◄
Important
If the flow of current to the tachograph is interrupted, the PIN
which was entered is retained. If the flow of current to the
CTC II is interrupted, the PIN will be lost.◄
Important
1 Press to select Input PIN.
2 Enter the PIN and confirm.
You can enter numerical values, letters and special
characters; see the note in Chapter 4.
3 End the program.
To Next Page
Loading...
