CTC II The steps involved in measuring and testing
Operating InstructionsThe steps involved in measuring and testing SmarTach
®
44 © Continental Trading GmbH A2C59512809
6.3 The steps involved in measuring and testing SmarTach
®
6.3.1 General notes
The execution of a measuring and testing procedure for a
SmarTach
®
differs from that of standard tachographs,
depending on the SmarTach's operating status (activated or
not activated).
SmarTach
®
is not
activated
In the case of a SmarTach
®
which has not been activated, you
can program the legal and non-legal parameters as individual
values (normal procedure).
SmarTach
®
is
activated
In the case of a SmarTach
®
which has been activated, you
can only program the non-legal parameters as individual
values (as normal).
The legal parameters can only be programmed during a full
calibration procedure; see the following Chapter.
Overview of the
parameters
Legal parameters Non-legal parameters
K constant
Wheel circumference
Odometer
VIN
Calibration date
Maximum speed
Country code
VRN
Tyre size
CAN configuration
Product code (read only)
Drive shaft PPR
Installation date (read only)
And more...
To Next Page
Loading...
