CTC II • Edition 01/2009
A2C59512809 © Continental Trading GmbH 43
The steps involved in measuring and testing
Rolling road test stand
1)
This function serves as a drive-in, drive-out function for the
vehicle and is only effective on a rolling road. Control of this
function is carried out by the CTC II.
When driving into the roller set the brake must be engaged.
2)
Before each characteristic coefficient "W", wheel
circumference or automatic measurement procedure is
carried out, the previously-determined correction value must
be entered; see Chapter 5 "Preparing for measuring" on
Page 35.
If no new correction value is entered, measurement will take
place using the saved value.
3)
Brake test stand: Enter number of drive axles and confirm.
4)
If the determined characteristic coefficient "W" deviates by
±1% from the set device constant, the K value must be
adjusted accordingly.
To Next Page
Loading...
