CTC II • Edition 01/2009
A2C59512809 © Continental Trading GmbH 81
Error messages
CTC II error messages
12.3.4 Roller Interface Module communication
Error message Cause/ Measure to correct error
1
Bluetooth connection to Roller Interface Module
does not exist.
Remark:
Also see field strength display in the basic menu.
Measures:
– Switch on the Roller Interface Module.
– Check Bluetooth signal's field strength.
– Change position/ angle of CTC II to Roller Interface
Module.
– Switch the Roller Interface Module off and on.
2
Bluetooth connection timeout occurred. Bluetooth
connection disconnected.
Measures:
– Check Bluetooth signal's field strength.
– Change position/ angle of CTC II to Roller Interface
Module.
– Switch the Roller Interface Module off and on.
3
A timeout for the acknowledgement of the start
signal has occurred.
Measures:
– Check Bluetooth signal's field strength.
– Change position/ angle of CTC II to Roller Interface
Module.
– Switch the Roller Interface Module off and on.
! ERROR !
INTERFACE
NO CONNECTION
CONTINUE WITH KEY
! ERROR !
INTERFACE
COMM. ERROR
CONTINUE WITH KEY
! ERROR !
START TIMEOUT
CONTINUE WITH KEY
To Next Page
Loading...
