CTC II The steps involved in measuring and testing
Operating Instructions Road measurement
38 © Continental Trading GmbH A2C59512809
6 The steps involved in measuring and testing
In order to program a tachograph, the "W" (characteristic
coefficient) and the "K" (device constant) values must be
determined and saved.
The determined values are documented in the test certificate/
inspection form (e. g. via KIPAS).
6.1 Road measurement
The CTC II reads the tachograph type and identifies it based
on the data it receives.
There is a special measuring and inspection procedure for the
SmarTach
®
; see Chapter 6.3
"The steps involved in measuring and testing SmarTach
®
" on
Page 44.◄
Important
The CTC II is set to the mobile function.
The CTC II is connected to the vehicle cigarette lighter via the
vehicle power supply cable.
The CTC II is connected to the tachograph.
The measured track has been prepared, also see Chapter 5
"Preparing for measuring" on Page 35.◄
Condition
Always adhere to your country's valid legal regulations!◄
Important
To Next Page
Loading...
