VDO CTC II - Displaying Manufacturing Data

CTC II Tachograph programming
Operating Instructions Displaying manufacturing data
68 © Continental Trading GmbH A2C59512809
10.4.4 Programming TCO
10.5 Displaying manufacturing data
1 Select "Date - Time > Programming TCO" and confirm.
2 Press or to select the position.
Use ... to enter the "date" (dd.mm.yy) and confirm.
3 Press or to select the position.
Use ... to enter the "system time" (hh.mm.ss) and confirm.
* The CTC II's system time corresponds to the local time.
4 End the program.
1 Select the "Manuf. data" menu and confirm.
The CTC II reads the tachograph type and parameter data.
2 Press to scroll through the manufacturing data:
– D = Date of manufacture
– L = Circuit board number
– S = Serial number
– V = Software version.
3 End the program.