CTC II • Edition 01/2009
A2C59512809 © Continental Trading GmbH 67
Tachograph programming
Date and Time
Changing change-
over times
In the Programming CTC menu, you change the stored
change-over times and add new times.
10.4.3 Programming CTC II
The modified values are now stored in the CTC II and must
then be programmed into the tachograph via the
Programming TCO menu.◄
Important
Time zone
1 Select "Date - Time > Programming CTC > Time zone" and
confirm.
2 Press or to set the time zone* (+ 11:00 h …- 12:00 h) and
confirm.
* You'll find the correct value in Chapter 10.4.1 "Time zones -
EU member states" on page 65.
Change-over times
3 Select "Change-over times" menu and confirm.
4 Press or to select the year and confirm.
5 Select the first text box (date begin daylight saving).
* You cannot change the time in the "end of daylight saving"
time text box as the CTC II determines this time based on the
start of daylight saving time and the offset.
6 Select the position.
Use ... to enter the "date" (dd.mm.yy) and "time"
(hh.mm.ss) and confirm.
7 Press or to select the "northern or southern hemisphere"
text box and use or to choose the correct setting.
8 Press or to select the "change over offset" text box and
use or to choose the correct setting.
9 Confirm your settings and end the program.
To Next Page
Loading...
