VDO CTC II - TCO Parameters Configuration

CTC II Tachograph programming
Operating Instructions TCO parameters
60 © Continental Trading GmbH A2C59512809
10.3 TCO parameters
Program Remark Value/ Information
Configuration See the MTCO Technical
Product Manual.
MTCO: binary entry
Seal number Will be defined by the
local Continental
subsidiary.
MTCO: 8-digit number
CAN on/ off Enabling or disabling the
CAN bus.
SE5000: on/ off
Reset Heartbeat CAN-based instrument
communication.
DTCO, SmarTach
®
, SE5000:
on/ off
Repetit. rate TCO1 As specified by the
vehicle manufacturer.
DTCO, SmarTach
®
, SE5000:
20 ms or 50 ms
Out of scope warn. Suppression of output on
CAN.
DTCO 1381 Rel. 1.3: on/ off
CAN2 TCO1 on/ off Enable TCO1 message
on CAN2.
DTCO 1381 Rel. 1.3: on/ off
CAN2 D3 wake up Wake up CAN2 via input
D3.
DTCO 1381 Rel. 1.3: on/ off
Revolution input
CAN/ C3
DTCO, SE5000:
CAN/ terminal C3
Dim mode Dimming input. • DTCO 1381 Rel. 1.3:
CAN/ terminal A2
• SE5000:
off/ CAN/ terminal A2
Can dimm mode DTCO 1381:
Standard/ Alternative