VDO CTC II - Saving and Transferring TCO Data

To Next Page

To Previous Page

CTC II • Edition 01/2009

A2C59512809 © Continental Trading GmbH 71

Tachograph programming

Saving TCO data

10.8 Saving TCO data

When replacing a tachograph, all vehicle-specific and device-

specific parameters must be programmed into the new

tachograph.

The CTC II enables you to read, save and program the

following parameters into the new tachograph:

• Select the "Save TCO Data" menu and confirm.

Parameter DTCO 1381 DTCO Rel. 1.3 SE5000 MTCO 1324

N constant

Odometer –

VIN

Drive shaft PPR

Maximum speed –

VRN –

Country code –

Tyre size –

Reset Heartbeat –

CAN1 repetition rate TCO1 –

Dim mode – – –

Dimming parameters –

Speed warning –

V profile –

N profile –

Warning expiry date

calibration

–

Additional inputs D1/D2 – –

Activity/ Ignition – –

Self-control level – –

V pulse monitoring – –

RPM input –

Other manuals for VDO CTC II