7-11
7 In-Tank Setup Meter Data Present
F - Removing Height/Volume Points
At the display below:
Press ENTER and if necessary, press STEP until you display the height/volume point you want to remove:
Press CHANGE:
Press ENTER to confirm:
Press STEP and follow the above procedure to continue removing height/volume points until you are finished.
Meter Data Present
If necessary, press STEP until you see the message:
When this feature is enabled, all meter data collected from the dispensers will be reported to the system. If
dispenser data for this tank is being reported to the DIM (i.e., meter data present), then this parameter MUST be
set to YES.
To enable the feature, press CHANGE then ENTER to confirm your choice. The system displays:
Press STEP to continue.
Vapor Loss Factor - International Option
If necessary, press STEP until you see the message:
Press CHANGE and enter the vapor loss factor. Allowable range 0.00 (default) to 0.20%. Press ENTER to
confirm your choice.
Press STEP to continue.
T1: REMOVE HEIGHT/VOL PT
PRESS <ENTER>
88.32 INCH VOL : 9200
T1 : REMOVE: NO
88.32 INCH VOL : 9200
T1 : REMOVE: YES
T1 : REMOVE: YES
PRESS <STEP> TO CONTINUE
T1: (Product Label)
METER DATA PRESENT: NO
METER DATA PRESENT: YES
PRESS <STEP> TO CONTINUE
T1: (Product Label)
VAPOR LOSS FACTOR: 0.00%
Ticketed Delivery must be enabled for this menu
to appear.
To Next Page
Loading...
Need help?
General
