3-3
3 Setup Mode Organization Setup Mode Programming Table
STEP
0.2 gph (0.76 lph) Line Test Auto-Confirm (Enable/Disable)
STEP
0.1 gph (0.38 lph) Line Test Auto-Confirm (Enable/Disable)
STEP
Daylight Savings Time (Disable/Enable)
STEP
HRM-QPLD Printouts (Enable/Disable)
STEP
Re-direct Local PrintouT (Enable/Disable)
STEP
Euro Protocol Prefix
STEP
Bdim Trans Alarm Delay
STEP
System Security Code
STEP
Maintenance History (Enable/Disable)
STEP
Tank Chart Se c urity
STEP
Custom Alarms
STEP
Service Notice
STEP
Inventory Alarms Threshold Units (Standard, All % Full, All Volume, All Height, Custom)
STEP
System Beeper (Enable/Disable)
STEP
Mass/Density
STEP
Fiscal Height Security
STEP
Alarm Reduction (Enable/Disable)
FUNCTION
COMMUNICATION SETUP
STEP
Comm Board Port Settings - Repeat for each board (Baud Rate/Parity/Stop Bit/Data Length/
Dial Type/Answer On/Code/Modem Setup String/Dial Tone Interval/DTR Normal State
STEP
Auto Transmit Setup (Transmit Message Setup/Auto-Transmit Delay Time/Auto-Transmit Repeat
Time)
STEP
Phone Directory Setup
STEP
Auto Dial Setup
STEP
Auto Dial Alarm
STEP
RS-232 End Of Message
FUNCTION
IN-TANK SETUP
STEP
Tank Config Module 1 (Up To 3)
STEP
Product Label
STEP
Product Code
STEP
Thermal Coeff.
STEP
Tank Density
STEP
Tank Diameter
STEP
Tank Profile (1 Pt/4 Pts/20 Pts/linear/50 Pts)
STEP
Full Volume
STEP
Meter Data Present
STEP
Vapor Loss Factor
STEP
End Factor (None/Flat/Hemispherical/Other)
STEP
End Value
STEP
Calibration Update
STEP
Float Size
STEP
Water Minimum
STEP
Water Warning Limit (Not Active For Tanks With High Alcohol Probes)
STEP
High Water Limit (Not Active For Tanks With High Alcohol Probes)
STEP
Water Alarm Filter (Not Active For Tanks With High Alcohol Probes)
STEP
Max Or Label Volume