Vermes MDS 3200A - Page 41

VTK‐VS‐BA‐004e‐B|UserManualMDS3200A | Communication Interfaces
41


Return: 2
Thenozzleiscorrectlyadjusted.Theadjustwassuccessful.

4. ADJUST:START
 Description: Sendingthisinstructioncausestheadjusttobeexecutedatonce.This
procedure,requiredduringeachinitialstart‐upandafterreplacingthe
nozzleunit,decidesonthepositionofthenozzleinsertwithrespectto
thetappet.Theresulthastobeverifiedbythepreviouslydescribed
commandno.3.
 Example: 
 Input: ADJUST:START
 Result: Theadjustisinitiated.
 Return: OK

5. HEATER:1:OFF
 Description: TheheaterconnectedtothesocketisswitchedOFF.
 Example: 
  Input: HEATER:1:OFF
  Result: Thenozzleheaterisdeactivated.
  Return: OK

6. HEATER:1:ON
 Description: Theheaterconnectedtothesocketisturnedon.Itisimportanttoknow
thatthisactionhasaninfluenceonthedelayselectedinthecurrent
parameterconfiguration.Ifavalue<4.6mshasbeenentered,itwill
automaticallybeincreasedtothislimit.
 Example: 
  Input: HEATER:1:ON
  Result: Thenozzleheaterisactivated.
  Return: OK

7. KEY:ENTER
 Description: Theacknowledgementsignalistransferredtothecontrolunit.
Thefunctioniscompletelyidenticaltopressingthe[enter]keyon
thekeypad.
 Example: 
  Input: KEY:ENTER
  Result: AnENTERsignalissent.
  Return: OK(nofurtherreaction)

8. KEY:ESCAPE
 Description: Likebypressingthe[esc]key,thisinstructionabortsthecurrentpro‐
grammingstepwithoutsaving.
 Example: 
 Input: KEY:ESCAPE
 Result: TheEscapesignalistransmitted.
 Return: OK(nofurtherreaction)