Summit & Summit 800
Feature Description and Operation Manual Issue 1.2
161
Condition
1. Caller Id will be the external caller who left the message or, for messages from another
station, Caller Id will be the station receiving the message.
2. If notification is disabled, any existing notification will be terminated after the initial
notification call.
3. For proper operation, the Station COS (Class of Service) and CO Group access for the
station must be such as to allow the notification call.
4. The Mobile telephone number to notify is assigned in PGM 236.
5. The system will continuously attempt to seize an outside Line for the notification call
until successful, if all lines in the assigned Line group are busy.
6. The Retry counter is incremented after the system accesses the outside Line for
notification.
7. The Retry count is from 1 to 9; the retry interval is from 1 to 3 minutes.
8. If a new message is logged before answer of the notification call, the message will be
available to the user and a new notification is not invoked. If a new message is
received after answering the notification call, the System will invoke another notification
call. The user will receive the notification after returning to idle.
9. An analog CO Line may be used for the notification however, notification over these
Lines (LCO Lines) must be enabled and several timers must be set to compensate for
the lack of answer and disconnect signals from an analog CO Line. The system will
treat the call as answered after VM Notify Play Delay Over LCO Timer then play the
new message prompt. The system will wait for you to enter a password for the VMIB
Group Dial Time Out. You must enter the correct password or the call will be
disconnected.
10. If you enter an incorrect password, the system will allow you to reenter a correct
password. You may retry entry for the DISA Retry Counter.
Programming
Keyset Admin.
To Next Page
Loading...
