Vertical summit - Station User Programming & Codes

Summit & Summit 800
Feature Description and Operation Manual Issue 1.2
378
5.25 Station User Programming & Codes
Description
You can program an array of functions and features, access status information and assign special
features codes to Flex buttons of your iPECS IP or LDP Phone. The Station User Program Codes
used for these purposes are fixed as listed below.
Code Description Entries
10 Enblock Dial
11x Intercom Differential Ring 1~8 (Level may be different)
12x Outside Line Differential Ring 1~8 (Level may be different)
13 Station Answer Mode 1: H, 2: T, 3: P
14x Call Coverage Attribute 1~2
15x Station Ring Download 5~ 8 + 0~9
19 Ear Mic. Headset
21 Knock down Station COS (Class of Service)
22 Restore Station COS (Class of Service) Auth code
23 Walking COS (Class of Service) Auth code
24 ICR Scenario Scenario Data
25 LIP Phone Statistics Real-time Packet Monitoring
26 Call profile Table Index 0-3
31 Station Message Wait Retrieve
32 CLI/IP Message Wait Retrieve
33 Register Authorization Code Auth Code
34 DID/DISA Call Wait
35 Choice Exec/Sec Message 1 On, 0 Off
36 SMS sending mode
37 Register Mobile Extension Tel. number
38 Activate Mobile Extension 1 On, 0 Off
39 Register Mobile Ext CLI Tel. number
30 VM Mobile notify 1 On, 0 Off
41 Set Wake-Up Time Once/Permanent & Hour/Min
42 Erase Wake-Up Time
51 Custom/Pre-selected Message 00~20
52 Register Custom Message (00) “Message”
53 Create Conference Room Room number (1~9)