Summit & Summit 800
Feature Description and Operation Manual Issue 1.2
366
5.17 Prime Line Immediate/Delayed
Description
When you go to an off-hook state, the system normally provides ICM dial tone. If desired, a
station can be assigned to access a different pre-assigned system resource (Prime Line). The
Prime Line can be any of the Idle Line Settings:
Seize an outside Line,
Call another station,
Activate a Flex button feature
Call to pre-assigned Hunt group
Call to pre-assigned station Speed
Call to pre-assigned system Speed
Prime Line access can be defined as immediate or delayed. When assigned immediate, upon an
off-hook event, the system provides access to the Prime Line. With Delayed Prime Line, you
receive normal Intercom dial tone for the Prime Line Delay timer and after the delay, the Prime
Line is accessed. This allows you to make a selection overriding the Prime Line.
Operation
iPECS IP & LDP Phones
To access the station’s Prime Line
1. Lift the handset or press [SPEAKER] button and take no action, Prime Line as assigned will
be accessed.
Conditions
1. Any of the station’s Flex buttons may be assigned as the Prime Line. When you lift the
handset or press the [SPEAKER] button, the system will act as if the Flex button had
pre-selected the button prior to going off-hook.
2. Selection of another Flex button or Feature button just prior to an off-hook event will
override the Prime Line assignment.
3. An SLT can be assigned an Idle Line Selection with a Speed Bin Number.
4. When Delayed Prime Line is set, you must wait, taking no action until the Prime Line is
accessed. You will receive ICM dial tone during this period and may dial any valid
numbering plan digit(s) or select a Flex button or feature button.
5. If the Prime Line Delay Timer is greater than Dial tone time-out, the Delayed Prime
Line will not activate. It will be necessary to reduce the delay timer or extend the Dial
tone time-out.
To Next Page
Loading...
