Vertiv Liebert CRV - Tools Required; Installing Tie-Down Brackets on 300-MM (12-In.) and on Cabinets of Different Heights

5.2.2 Tools Required
• Screwdriver, Phillips #2 Bit
• Drill
• Drill bit: 1/8” diameter
• 10 mm wrench or adjustable wrench
5.2.3 Installing Tie-down Brackets on300-mm(12-in.)
andonCabinetsofDifferentHeights
To install the tie-down bracket:
1. Insert the M6 bolt through the longest slot in the two-piece tie-down bracket as shown in
Figure 5.3 on the facing page.
2. Secure the tie-down bracket loosely with the washer and M6 nut.
3. Position the tie-down bracket over the factory-fabricated holes on the top of the Liebert CRV
and over the top of the adjacent cabinet as shown in Figure 5.3 on the facing page.
4. Mark where the self-tapping screws will attach the tie-down bracket to the adjacent cabinet.
5. Taking proper precautions to collect the metal shavings and protect equipment, drill holes in
the adjacent cabinet for the two screws.
6. Use a vacuum cleaner or other method to remove all metal particles.
7. Position the bracket over the holes in the Liebert CRV and the adjacent cabinet.
Vertiv | Liebert CRV Installer/User Guide | 30