5 INSTALLING IN ENCLOSURE ROW
Built-in casters let you roll the Liebert CRV into position for installation. Stabilizers reduce the likelihood of
the module tipping over. These stabilizers, shown in Figure 5.1 on the next page, must be removed before
the unit is positioned in the row. Adjustable leveling feet prevent it from moving after positioning, See
Adjusting Base Supports/Leveling Feet below.
Once positioned, secure the unit to the floor or to an adjacent cabinet.
Adjustable brackets for attaching the unit to an adjacent cabinet are included with each unit. A bracket
to attach the unit to the floor is available from your Vertiv™ representative.
5.1 Adjusting Base Supports/Leveling Feet
1. After the unit is in its final installation position, open the display door and remove the lower
front baffle panel using a 10-mm nut-driver or T30 Torx Bit to prepare for installation.
2. Open the rear panel.
3. Using an adjustable wrench, adjust the four base supports, or feet, shown in Figure 5.1 on the
next page. Ensure that the unit is level to avoid corrosion or health hazards caused by
condensate accumulation.
a. Turning the base supports (leveling feet) clockwise, extends them, and lifts the unit one
corner at a time.
b. Tighten the nut on the top of each foot to lock the feet. The nut on 600-mm (24-in.) units
is inside the cabinet. The nut on 300-mm (24-in.) units is under the cabinet, as shown in
Figure 5.2 on page29.
Vertiv | Liebert CRV Installer/User Guide | 27
To Next Page
Loading...
