VYBO Electric Vector V800 - Group P6: Output Terminals

Chapter 4: List of function parameters - shorted
67
Group P6: Output terminals
Function
code
Parameter name
Setting range
Default
setting
Attribute
P6.00
M01 output mode
1: Turn on the output signal (M01)
1
☆
P6.01
Functions M01
(0 – 40)
0: No output
1: Inverter in RUN mode
2: Output error (stop)
3: Detection of the FDT1 frequency level
4: Frequency achieved
5: Run at zero speed
6: Pre-warning of overloading the motor
7: Pre-warning of overloading the inverter
8: Set counter value reached
9: Required value of counter reached
10: Length reached
11: The entire PLC cycle completed
12: The cumulative operating time reached
13: Limited frequency
14: Limited torque
15: The inverter is ready to RUN
16: FIV>FIC
17: The upper frequency limit reached
18: The lower frequency limit reached
19: Under voltage
20: Communication setting
21: Reserved
22: Reserved
23: Run at zero speed
24: Total time Under voltage reached
25: Detection of the FDT2 frequency level
26: Frequency reached 1
27: Frequency reached 2
28: Current reached 1
29: Current reached 2
30: Time reached
31: FIV entry limit exceeded
32: Zero load
33: Reverse RUN
34: Zero current
35: Module temperature reached
36: Exceeded output current limit
37: Frequency lower limit reached
38: Output alarm (continues to run)
39: Reserved
40: Current running time reached
0
☆