VYBO Electric Vector V800 - Chapter 4: List of Function Parameters - Abbreviated; Group P0: Basic Parameters

Chapter 4: List of function parameters - shorted
52
Chapter 4: The list of function parameters - shortened
If parameter PP.00 is set to a nonzero number, parameter protection is enabled. To enter
the menu, you must enter the correct user password. To disable password protection,
enter your password and set PP.00 to 0.
The parameter menu customized by the user is not password protected. Group P is the
basic parameters of the functions, group D is for monitoring of functional parameters.
The meaning of the symbols in the function code table is as follows:
„☆“The parameter can be changed when the inverter is in a stopped or running state.
„★“The parameter cannot be changed when the inverter is in a running state.
„●“The parameter is actually a measured value and cannot be changed.
„*“This parameter is a factory parameter and can only be set by the manufacturer.
Function
code
Parameter name
Setting range
Default
setting
Attribute
Group P0: Parameters of standard functions
P0.00
G/P type*
1: G type (constant torque load)
2: P type (variable torque, eg fan,
compressor, pump, etc.)
*by the
model
★
P0.01
Selecting the
control mode
0: Voltage / frequency control
(V/F)
1: Flow vector control without sensor
(SFVC)
0
★