BA 357-00 * 3.0 * 35700_04_Inbetriebnahme_03.fm 4-45
Putting into operation 4
Requirements and information for the operating personnel
• The operating personnel (operator) must have read and understood
this Operator’s Manual before putting the machine into operation.
• The machine may only be put into operation by authorized personnel
that have been instructed.
• The machine may only be put into operation when the operator is
seated.
• Never get on a moving machine. Never jump off the machine.
• Before leaving the machine, lower the loading unit to the ground, turn
off the machine and remove the ignition key.
• Carrying or transporting accompanying persons in the cabin and/or on
the machine is prohibited.
• Tell persons to leave the danger zone.
• The machine may only be used in technically perfect condition in
accordance with its designated use and the instructions set forth in the
operation license, the Data Confirmation (Germany) and in the
Operator’s Manual, and only by persons who are fully aware of the
risks involved in operating the machine.
• Always observe the warning and information labels.
• Fasten the seat belt (lap belt).
• Always observe the warning and information labels, and the load
diagrams (for example pallet forks) of the loader unit.
• Immediately replace (or have replaced) damaged or illegible warning
and information labels with new ones.
• Adjust the rearview mirrors on the left and right.
• Pay attention to the checklist
– see "Information on the checklists" on page 4-47.
To Next Page
Loading...
Need help?
General
