5-78 BA 357-00 * 3.0 * 35700_05_Bedienung.fm
5 Operation
Loading vehicles
1. If possible, the truck and the working direction of the machine should
form an angle of 45°.
2. Only raise the full bucket to the tilt-out height when the vehicle travels
in a straight line toward the truck.
If possible load material with the wind behind you to keep the dust away
from your eyes, air filters and fans.
Freeing the machine
Proceed as follows if the machine should get stuck when picking up
material:
1. Tilt out the bucket until the blade is vertical above the ground.
2. Lower the loader unit all the way.
3. Gradually tilt in the bucket.
➥ The vehicle is pushed backward.
4. Reverse slowly.
5. Repeat this procedure until the wheels reach firm ground.
6. Reverse the vehicle away.
To Next Page
Loading...
Need help?
General
