Wacker Neuson KRAMER 5055e User Manual

BA 357-00 * 3.0 * 35700_05_Bedienung.fm 5-109
Operation 5
Switching the load stabilizer ON and OFF
Information
When switching the load stabilizer on or off, the loader unit is subject to
compensation movements from pressure or loading balancing!
► We therefore recommend always turning off the load stabilizer before
working with pallet forks.
The load stabilizer can be used in automatic and continuous mode.
• The load stabilizer in automatic mode is suitable for machine travel on
public roads, for lighter work with the loader unit and for light off-road
transport.
It is switched on and off by means of a travel speed control
➥ Travel speed over 7 km/h => ON
➥ Travel speed below 6 km/h => OFF
• The continuous operation is suitable for longer trips off-road or on
public roads.
The tilt switch 60 for load stabilizer operation is located on the switch
console below the steering wheel.
Fig. 199
B
60
A
C
Operation Function
Continuous
operation
ON
Press switch 60
to position C.
➥ Load stabilizer switched on.
➥ The LED in the switch illuminates.
AUTO
Press switch 60
to position A.
➥ Load stabilizer switched on in
continuous operation: load
stabilizer is operation at speeds
over 7 km/h
Below 6 km/h and the load
stabilizer is out of operation.
➥ The LED in the switch illuminates.
AUS
Press switch 60
to position B.
➥ Load stabilizer switched off.
➥ The LED in the switch extinguishes.

Wacker Neuson KRAMER 5055e Specifications

General

Brand	Wacker Neuson
Model	KRAMER 5055e
Category	Front End Loaders
Language	English