5-112 BA 357-00 * 3.0 * 35700_05_Bedienung.fm
5 Operation
Undertaking decommissioning for longer periods of time
1. Perform all the measures related to decommissioning
– see "Activities in preparation for decommissioning" on page 5-111.
2. If possible, retract the piston rods of the hydraulic rams to protect them
against damage. If this is not possible, apply grease to the piston rods
and to the bare parts of the hydraulic rams that are not paint-coated.
3. Remove the battery and store in a well-ventilated
and cool and frost-free space.
Putting the machine back into operation
1. If necessary, have the battery checked and installed.
2. Check tire inflation pressure.
3. Clean the piston rods. However, when doing this, do not use grease
solvents or a high-pressure cleaner.
➥ The scraper bar is not water resistant.
➥ Water in the guide bushing causes corrosion and damage to the
piston rod.
4. Connect the battery connector.
5. Check the operation of the electrical system.
6. Check the operation of the steering and brakes.
To Next Page
Loading...
Need help?
General
